0161 818 2461

You have no items in your shopping cart.

Product was successfully added to your shopping cart.

NUX NCP-2 Sculpture Compressor Pedal

Quick Overview

Availability: Out of stock



The NUX Sculpture Compressor pedal offers a consistent volume output level and sharpens the signals on top and bottom edges. When you start picking your guitar, it will clean the loud (peak) notes and increase the sustain by raising the level of decaying (quiet) notes. Sculpture also contributes to the signal foundation that's fed into the rest of your effects chain.

It has 2 clip modes, simply switch between “Clean Mode” and “Clip Mode” by holding the switch for 1 second.

Clean Mode

The clean mode has a wide range from bottom to top so if your guitar slams the limits too hard (like humbucker pickups) it can control the compression. You can also dial up a very soft and clean compressor for single coil system guitars in Clean mode.

NUX Sculpture No Clip


NUX Sculpture Soft Clip

Clip Mode (Clip Light is On)

If you want to squeeze your sound, Clip Mode will make it tight and the compressor will wrap all over the signal. It is very suitable for the single coil guitars to compensate the weak output.

NUX Sculpture Hard Clipping

Blend Knob

When you adjust the knobs to catch a perfect balance between clipped frequencies and a good sustain, the blend circuit allows you to adjust the dry/wet compressor effect level on the processed signal. Whatever you dial-up on the Sculpture Compressor, you can simply adjust the opacity of the effected sound.

True Bypass / Buffer Bypass

The Sculpture Compressor has an embedded selectable buffer bypass.


Input Impedance:1M ohm

Output Impedance:20 ohm

Power Input:Standard 9V DC, center negative >100mA (power supply not included)

Weight:174g/ 6 oz

Dimensions:94(L)×51(W)×53(H)mm | 3.7(L)×2.0(W)×2.08(H)inches


Additional Information

Brand Nux